軌道平車電池的連接須保持良好的接觸

軌道平車電池的連接須保持良好的接觸，以避免火花燒壞電極或使電池爆炸。電池應避免過充，過放，強充電和充電不足，否則會縮短電池壽命。請勿將任何有害物質滴入電池。用于測量電解液密度，溫度和液位的儀器和器具應保持清潔，以避免將雜質引入電池。請勿在電池蓋上放置任何導電物體，以免發生短路。

軌道平車電池放電后，應及時充電，較長間隔不超過24小時。使用電池時，如果電池有電池，應查明原因并立即進行修理。 如果無法修復，請更換新的。注入電池的水和硫酸溶液應在10至35°C之間，且不應過高或過低。充電室嚴禁煙花爆竹，以免發生氫氣爆炸事故。 充電室應通風良好，室溫不應低于15°C。

軌道平車使用電池時，通常存在電壓，密度和容量不平衡。 為了實現電池的均衡和一致的使用狀態，電池應每月充電一次。 如果出現下列情況之一，應執行平衡充電：

放電電壓經常低于終止電壓;放電電流值通常過大時;出院后未及時充電;當電解質混入無害的雜質時;經常在較長時間內充電不足或未使用;檢查或清除沉淀物后，拆下極組。

均衡充電方法：先正常充電，等待充電，靜置1小時，然后繼續正常充電二階段充電，直到產生劇烈氣泡，停止充電1小時。重復幾次直到電壓和密度保持不變，并且在該間隔之后進行充電以立即產生尖銳的氣泡。